Keypad Instructions

Arming Levels

1. How do I change my primary user code?
   
   Press 8, enter your primary user code, press #, press # again to display the current primary user code, enter your new primary user code, and press #.
   

2. How do I add or delete a user code on my system?
   
   

   Press 8, enter your primary user code, press #, press ▼ until the desired user code is reached, press # again to display the current user (2-4) code (if any), enter the desired user code and press #.
   
   You can have 1 primary user code and up to 3 user codes on this system.
   
   To delete a user code, press 8, enter your primary user code, press #, press ▼ until the desired user code is reached, press # twice to delete the user code.
   

3. How do I change the time display?
   
   

   Press▼, press  # to display the time, enter the current time and press ▼ to select AM or PM,  press  # to exit.

4. How much time do I have to leave or enter the building?
   
   

   All of our systems are programmed so that you will have 45 seconds to exit the building and 30 seconds to enter the building and disarm the system.
   
   There may be occasions and circumstances where the system has been programmed for either shorter or longer exit & entrance times. The installing technician would have recorded and conveyed this to the subscriber at the time of installation or programming.

5. How do I reset my smoke detector?
   
   

   The smoke detector(s) will reset itself automatically once smoke has cleared from the smoke detector area(s).